* Some networks may charge for the call please check with your provider.

We provide Plumbers, Emergency Plumbers  and a Plumbing Service all over the UK including:

Berkshire

Essex

Hampshire

Kent

Nottinghamshire

Surrey

Sussex

London

Derbyshire

Dorset

•  CYLINDERS

•  IMMERSIONS

•  STOPCOCKS

•  OVERFLOWS

•  BALL VALVES

•  LEAKS

•  BURST PIPES

•  TANKS

•  TAPS

•  SHOWERS

•  SINKS

•  OUTSIDE TAPS

•  TOILETS

Tips and Advice for Emergencies

 

Cutting off the water supply in an emergency

 

If your tap is connected to the mains, it is relatively simple to cut off the supply. Turn off the indoor stop valve. If it is stiff, it is advisable to use a spanner, or to apply a little oil if necessary. When this has been done, simply drain the remaining water away by turning on the taps until the flow of water has stopped.

 

If your hot or cold tap feeds off pipes from the cistern (water tank) , there should be either a gate valve or mini stopcock available to turn off. The stop valve can be found alongside the cold water tank. When these have been turned off, switch on the tap until the water flow has stopped.

 

N.B. If you find that neither the gate valve or the stopcock are present, then the cistern itself will have to be drained. To drain the cistern you must first prevent water entering the system by switching it off at the mains. Alternatively you can tie up the ball-valve by placing a piece of wood across the tank and tying the arm of the ball-valve to it. Either way, the flow of water will be stopped. The bathroom taps can then be turned on to drain out the remaining water.

 

If for some reason you wish to turn off the outdoor stopcock, you will first need to find it outside of your property. If you cannot locate it, get in touch with your water company. Take of the cover off, and insert the stopcock key. When you have reached the handle at the bottom, turn it clockwise to cut off the flow.

 

Always know where your stopcock is and make sure it turns the water supply off. If it stiff and seized up look for were your water supply isolates outside the boundry of your property. If this is deep and filled with earth it will be difficult to turn off. Try to check the stopcock every month or two to keep it working.

 

If there are tanks in the loft make sure you know how to isolate the supplies to them, perhaps there are some valves in your airing cupboard?

Keep all pipe work in exposed areas i.e in the loft or outside insulated to protect it from freezing.

 

Know where to drain your heating system from. This will be a small valve under one or two of the downstairs radiators. It can also be outside. It can save a lot of time looking for it!

If a tap has started dripping, it will probably be just a washer. If is left it can cause damage to the tap which may be irreparable.

 

Next time you are in the loft check the tanks up there – they should be well insulated and have a secure lid. Check that there is not debris in the tanks (especially dead birds– nice water for brushing your teeth in). This can block the outlet and cause bigger problems further down the line.

 

After the summer you may find some of the Thermostatic radiator valves(TRV) pin may become stuck (the radiator will be cold when the heating is on) Try unscrewing the TRV and gently pulling the small pin upwards with a pair of pliars. This should release it and the radiator should now get hot.

 

The radiator is cold at the top and not at the bottom – generally caused by air. This can be removed by venting / bleeding the radiator. Use a vent key (purchased from most hardware shops) bleed / vent until water comes out.